Archive for August, 2013

FCoE with Intel 82599 10Gbit connections

So in my lab I’ve got a Cisco Nexus 5548 and a SuperMicro SuperServer 6026-6RFT+.  I’ve put Nexenta on this, Windows, and several other things.  One thing I hadn’t tried is running FCoE.  Intel announced FCoE support for all Nintanic based chips several years ago, and I hadn’t tried it.

I figured this was as good of a time as any to play with ESXi and FCoE so I dug in.  ESXi 5.1 installed flawlessly.  It saw all of the NIC’s, all of the hard drives, everything.  The Nexus 5548 worked great, I sailed along creating new vSAN’s for FCoE, and thought, “here we go!”.

I followed the guide here for enabling FCoE http://www.intel.com/content/www/us/en/network-adapters/10-gigabit-network-adapters/ethernet-x520-configuring-fcoe-vmware-esxi-5-guide.html.  It all looked splendid until I actually got to the part where you activate the new FCoE Storage adapter.  Every time I tried to add the Software FCoE adapter, it acted like there was no available adapter that supported FCoE.  I knew this wasn’t the case, as it was very clearly mentioned that it _was_ supported.

After several hours of poking, prodding, trying different versions of ESXi, updating the system board BIOS, tinkering with BIOS settings, trying Windows – thinking maybe, just maybe ESXi wasn’t going to work, I gave up and sent an email to Intel.

Intel responded very graciously that since it was an integrated controller on the system board, there wasn’t much they could do for me, and that I would have to talk to my manufacturer.  I followed their advice, contacted SuperMicro, and got a fantastic response.

Matt,
Would you don’t mind flash the EEPROM firmware. The firmware release on 08/09/11 will allow Intel 82599EB to support FCoE.

X8DTU-6TF_EEPROM.zip

Steps to flash onboard LAN EEPROM

1.Extract the files and Copy them to a bootable USB stick or to a bootable floppy disk.
(If you don’t have a bootable USB stick you can make it using:
http://www.softpedia.com/get/System/Boot-Manager-Disk/BootFlashDOS.shtml
http://www.sevenforums.com/tutorials/46707-ms-dos-bootable-flash-drive-create.html).

2.Boot up the system using the USB stick.

3.At the command prompt type —  <filename>.bat

4.Enter the 12 digit LAN1 MAC address, when prompted.

5.Power cycle the system.

6.Reinstall the LAN drivers after EEPROM is flashed.

 

Technical Support
ES

 

After flashing the new EEPROM on to the LAN controller, I was able to sucessfully enable FCoE for this system using ESXi (and subsequently Windows Server 2008R2).

Tuesday, August 27th, 2013 Configuration, Hardware, Virtualization 2 Comments